Amercoat 235, multi-purpose epoxy

Product Data Exceptional corrosion protection in salt and fresh water immersion and corrosive chemical environments Surface tolerant, lowers the cost of surface preparation Excellent adhesion to tight rust Good adhesion to damp surfaces Low temperature cure, cures down to 0°F (-18°C) Fast dry-to-recoat Self-priming VOC lb/gal g/L mixed 2.4 292 Volume solids (ASTM D2697 modified) 68% ± 3% Low solvent content meets VOC requirements, reduces the chances for film pinholing and solvent entrapment at the substrate-coating interface, often a major cause of coating failure with conventional epoxies and lower solids systems. Typical Uses Tank Linings and Pipe Coatings Ballast tanks Bilges, wet voids and drainage pipes Ships, Offshore and Marine Structures Above and below-water hull areas Decks and superstructures Multi-purpose repair coating Fabrication and New Construction Speeds up production, even at low temperatures A single multi-purpose, surface-tolerant coating Qualifications MIL-PRF-23236C, Type V, Class 7, Class 5 (for topside and underwater hull) Type 1 and IV Class 2 Canada Health and Welfare, dry food, fish holds (off white and buff only) USDA approval for incidental food contact (limited colors) MIL-P-24647 and Chapter 631, Table 631-8-10, keel to rail and exterior topside Systems Using Amercoat 235 1st Coat 2nd Coat 3rd Coat Amercoat 235 - - Amercoat 235 Amercoat 235 - Amercoat 235 Amercoat 229 - Amercoat 235 Amercoat 235 ABC #3 Amercoat 235 Amercoat 235 Amercoat 214 dimetcote 9 Amercoat 235 - Dimetcote 302H Amercoat 235 - dimetcote 9 Amercoat 235 Amercoat 450H Dimetcote 302H Amercoat 235 Amercoat 450H Recommended Thinners Amercoat T-10 Amercoat 65 Amercoat 101 Recommended Cleaner Amercoat 12 or Thinner Click here for Product Data Sheets (page will open in new window)